Dustbane Quatromyicide Hard Surface Disinfectant, 4L

Dustbane Quatromyicide Hard Surface Disinfectant. 4L

Quatromyicide V is a broad-spectrum disinfectant and sanitizer that has been formulated to aid in the reduction of cross-contamination on treated surfaces not only in hospitals, but in schools, institutions, and industries where disinfection, sanitization, and deodorization is of prime importance.

This product is part of Health Canada's list of hard-surface disinfectants with evidence against COVID-19.

How To Use
Dilute according to the dilution rates mentioned on the label in potable water. Apply using a mop, sponge, cloth, or trigger sprayer.

Disinfection: Heavily soiled surfaces must be cleaned prior to disinfection. Thoroughly apply diluted solution to wet the surface. For disinfection, allow to remain wet for 10 minutes then remove excess liquid.

Sanitizing: To sanitize surfaces, clean surface with a good detergent and rinse with potable water. Spray the solution onto the surface to thoroughly wet the surface. Allow the surface to remain thoroughly wet for at least 60 seconds. Remove excess liquid and allow to air dry on the treated surface. No rinsing required.

Third sink sanitizing: Equipment and utensils must be thoroughly pre-scraped and when necessary pre-soaked to remove gross food particles and soil. Scrape and pre-wash utensils and glasses whenever possible. Thoroughly wash equipment and utensils in hot detergent solution. Rinse with clean water. Sanitize in a solution of 60 ml of this product per 30 L of water (or equivalent dilution) for at least 60 seconds making sure to immerse completely. Remove items and place them on a rack or dram board to air dry. Do not rinse. Fresh sanitizing solution should be prepared at least daily or when visibly soiled or diluted.